What Are The Steps To Install Security Doors In Melbourne?

Home security doors in Melbourne have become a popular alternative for many homes nowadays. When it comes to home security, this solution is not only cost-effective, but also quite dependable. While many traditional home doors are made of wood, home security doors are generally composed of iron or steel, which may add an extra degree of security to modern homes. Because of their weight and metal design, these gateways are more resistant to force and largely fireproof. Furthermore, this type of door may give a thief the impression that the property is too unsafe for him or her to enter.

Because of its hefty weight and durability, most people believe that installing a home security door is a job best left to a professional. On the contrary, installation is a reasonably simple and short process. In reality, many do-it-yourself homeowners have successfully installed their home security doors without the aid of a professional and with only a few pieces of equipment. The instructions below will show you how to install home security doors as a homeowner.

Materials needed for installing security door:

–        Little silicone tubing

–        Level

–        Screw security head bit

–        Drill

–        Hammer

–        Penny nails

–        Handsaw

–        Chop saw

–        Measuring tape

–        Crowbar

–        Gloves

–        Eye protection goggles

The following is the procedure for installing a security door:

Ø  Step 1

Measure the width and height of your privacy security door. Check to see if the brick mold on your present door is at least 1 inch by inch by inch. By the way, the brick mold is the trim around the edge of the door frame to which your new security door will be fastened.

Ø  Step 2

Remove the old brick mold using a crowbar if it has to be replaced. Try to preserve it in one piece so you may use it as a template later. Then, using a saw, cut a new brick mold to width and length.

Ø  Step 3

Using a hammer and a few penny nails, secure the freshly produced brick mold to the door. Put these nails into the mold every couple of feet as you make your way through the door.

Ø  Step 4

Attach the door frame by screwing its security lags through the pre-drilled holes. Use a cordless drill to make your life easier. Also, remember to have someone keep the door open while you install the lags from side to side.

Ø  Step 5

Using a drill and the included screws, attach the door to the hinges.

Ø  Step 6

Close and reopen the freshly installed door many times to ensure that it does not bind.

Ø  Step 7

Install a new deadbolt and lock-set according to the manufacturer's directions.

Ø  Step 8

Apply silicone to the outside border of the brick mold. Cut your silicone tube at a 45-degree angle and put it to the mold.

We hope this brief guide was helpful for you. If you are looking to find the best security doors in Melbourne, make sure to visit us at Clear Breeze Security Doors!